Replaces
Genuine original equipment part (OEM) that was factory installed on your vehicle by the manufacturer.
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Attention California Customers:
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
1 Year Warranty
This item is backed by our 1-year warranty. In the event this item should fail during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii and Alaska.
Shipping is not available to a P.O. Box, APO/FPO/DPO addresses, US Territories, or Canada for this item.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii.
Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
To do the tail light, first you need to let the tailgate down, so we'll come over here, grab the tailgate handle, and open it up. Inside here you're going to notice a T25 Torx screw right here and right here. We're going to remove both of those with a T25 Torx bit on a ratchet. All right, there's one. Okay. At this point we should be able to just pull on it and it'll slide right off of these two tabs. You can see right here and right here. They line up with the tabs on the body, which hold it in place. We'll turn this 45 degrees and pop the upper light out. We'll do the same on the bottom. Pop that bulb out. Now your taillight is completely removed from the truck.
To reinstall, you'll put your lower bulb in. It's the smaller one. You'll turn it about 45 degrees to lock it in place. Up here you'll do the upper bulb. Same thing: turn it 45 degrees and lock it in place.
To reinstall, you just want to slide these tabs over these clips like so. Now we're going to take our T25 screws and our socket and put them right back in the holes. These are something that want to just be tightened just over hand tight. It's very easy to tighten these too much and start breaking things. If you're putting your muscle from your elbow to it, you're putting too much. You just want to use a little bit of your hand muscle to get this done. That is plenty. Now it's installed. Now we can shut the tailgate and be done.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
