How to Change Fog Light Bulbs 2003-08 Honda Pilot
Created on: 2017-08-07
How to install, repair, fix, change, or replace a broken, damaged, burned out, cracked, faded, cloudy or chipped fog light on 07 Honda Pilot
-
step 1 :Removing the Splash Shield
- Pry out the clip with a flat blade screwdriver
- Remove the 10mm bolt
- Pull the shield down to access the bulbs
-
step 2 :Servicing the Bulbs
- Disconnect the wiring harness
- Twist the bulb socket counterclockwise out of the light
- Pull the bulb off of the socket
- Push on the new bulb
- Twist the bulb clockwise into the light
- Connect the wiring harness
-
step 3 :Installing the Splash Shield
- Press the splash shield into place
- Press on the clip to the shield
- Tighten the 10mm bolt to the shield
Tools needed
-
Flat Blade Screwdriver
10mm Wrench
Change the fog light bulbs. We've got our vehicle up on the lift, but you can do this on the ground.
I'll take a small, flat-bladed screwdriver and remove this clip. You would have to undo this 10 mm bolt. Ours on the splash shield part where it goes through the bolt or around the bolt has broken, so I'm able to just pull it down.
The bulb is right here at the back of the fog light housing. You can unclip it. Pull the connector off. Turn the bulb counterclockwise. Take the bulb out.
This is an H11 bulb. We're going to reinstall it. Turn it clockwise. Once it goes into the slots, we'll lock it. Plug it back into the connector, and the bulb is changed.
Place our cover back up. Click on there. Find the hole for the push pin. If this bolt can be removed, now is the time to reinstall it.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Used Car or Truck Came With Wiring Hackjob How to Clean Up Spliced Wiring Messes
Len shows you how to clean up some sloppy wiring splices in your car or truck.
