How to Change Oil 2001-06 Chrysler Sebring 2-7l V6
Created on: 2013-10-31
Watch this video and learn how to properly replace the oil yourself with these step-by-step instructions
-
step 1 :Draining the Oil
- Raise the vehicle on jack stands
- Place a drain pan underneath the drain
- Remove the 13mm bolt from the drain
- Drain the oil
- Twist on the 13mm drain bolt
- Tighten the bolt with a 13mm wrench or socket and ratchet
-
step 2 :Removing the Oil Filter
- Remove the oil filter with an oil filter wrench
- Clean the area with a rag
- Installing the Oil Filter
- Place a layer of oil around the rim of the oil filter
- Twist the oil filter into place
-
step 3 :Servicing the Oil
- Remove the oil cap
- Place a funnel into the oil fill
- Replace the oil to the recommended amount
- Replace the oil cap
- Start the vehicle
- Turn the vehicle off
- Check the oil level with the dipstick
Tools needed
-
Funnel
13mm Socket
Oil Filter Wrench
Jack Stands
Ratchet
Floor Jack
Engine Oil
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to change the oil in this 2004 Chrysler Sebring. The tools that you're going to need for this are jack and jack stands, 15mm socket, and rachet, oil filter wrench, oil, and a new oil filter.
Now right here is your oil pan, and you just want to remove this plug right here. You just want to get a drift pin and put it underneath it. Then loosen up that plug, pull it out, and let your oil drain. When it stops draining just replace that 13mm plug.
Now, using an oil filter wrench, just remove your oil filter. Once you get a certain distance, oil will start coming down. Let that drain out and then remove it the rest of the way.
Be sure to clean the area where your oil filter seals, coat the gasket of the oil filter with a little bit of fresh oil, and spin your oil filter into place. Generally you want to make it as tight as you can by hand which is usually about 3 quarters of a turn after it seated.
Make sure that your drain plug is tight and refill your crank case. Check your owner's manual to see how much oil your car takes and also just refill it until a dipstick's at its full. Run the engine a little bit, check it again, and refill it as necessary.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
How to Change Engine Oil 2003-11 Honda Element
How to change the oil on 03, 04, 05, 06, 07, 08, 09, 10, 11 Honda Element
