How to Install Blower Motor Resistor 2007-14 Chevy Suburban
Created on: 2017-08-03
How to repair, install, fix, change or replace a bad or broken blower motor fan speed resistor on 09 Chevy Suburban
-
step 1 :Removing the Sound Cover
- Remove the two 7mm screws from the sound cover
- Peel the baffle down
-
step 2 :Removing the Blower Motor Resistor
- Remove the two 7/32 screws from the resistor
- Pull the resistor down
- Disconnect the wiring harness
-
step 3 :Installing the Blower Motor Resistor
- Connect the wiring harness
- Lift the blower motor resistor up into place
- Tighten the two 7/32 screws
-
step 4 :Installing the Sound Cover
- Insert the cover into place
- Tighten the two 7mm screws to the cover
Tools needed
-
Socket Extensions
7mm Socket
Ratchet
7/32 Inch Socket
Hi, I'm Mike from 1A Auto. We've been selling auto parts for over 30 years. We're dedicated to delivering quality auto parts, expert customer service, fast and free shipping, all backed by our 100% satisfaction guarantee. Visit us at 1AAuto.com, your trusted source for quality auto parts.
I'll remove this arm baffle. This is held on by two 7 mm screws. There's one under here and one over here. So I'm going to use my 7 mm ratchet and socket, and start removing them. With the two 7 mm screws removed, there is a hidden one behind the console here. This sound cover has a lot of flex in it. I'm just going to pull it down.
Now with the cover lowered, you can see the blow motor resister right here. So there's two 7/32 screws, one here and one in the backside. We're going to remove those. So I'm just using a 7/32 quarter inch drive socket with an extension on my ratchet, so it's easy reach behind here. I'm just going to hold this my other hand as I loosen it. Pull out the resister. Pull this out and unplug it. Push the locking tabs. This other locking tab. And remove the resister.
Our blow motor resister is working okay and we're going to reinstall it. These posts can only go in one way. I'll take that tape off, it's falling off. Move it up into the heater box. Reinstall the 7/32 self-tapping screws using a 7/32 socket ratchet with an extension. Just using my fingertips to tighten these til they get tight and then I'm stopping. Right there.
Push our plastic sound cover back up. There's a couple of ducts to fit over, over here. Install our 7 mm self-tapping screws and put that inside, and use my fingers to tighten these just til I feel them stop. Install the other one that's under here. I'm just going to use my fingers. Just as it gets tight I stop.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Cars Alternator Mounting Bolt Broke Try This Quick Fix
In this video, Len shows you how to do a quick fix to replace the alternator bolt in your car or truck, and gives you tips, and details you won't want to miss!
