How to Remove Bumper 2008-12 Ford Escape

1. step 1 :Removing the Bumper Cover 0:44

   • Pry up the clips from the radiator shield
   • Lift the radiator shield
   • Remove the three clips from the center grille piece
   • Raise and secure the vehicle with a jack and jack stands
   • Remove the 10mm bolts from the splash shield
   • Lower the splash shield
   • Disconnect the fog light wiring harness
   • Turn the lock pin in the wheel well with a flat blade screwdriver
   • Pry the lock pin up
   • Remove the Phillips screw from the wheel well
   • Remove the three body clips from the grille and headlight assemblies with a flat blade screwdriver
   • Pry out the edges of the bumper on either side
   • Remove the bumper

2. step 2 :Installing the Bumper Cover 4:48

   • Lift the bumper cover up into place
   • Press the sides of the bumper cover in
   • Connect the three trim pieces to the grille and headlight assemblies
   • Connect the fog light wiring harness
   • Press the splash shield into place
   • Tighten the 10mm bolts to the splash shield
   • Tighten the clip in the wheel well with a flat blade screwdriver
   • Tighten the Phillips screw in the wheel well
   • Press the clips to the center grille piece
   • Insert the radiator shield into place
   • Press the seven clips to the shield

Tools needed

• Socket Extensions

  Flat Blade Screwdriver

  Phillips Head Screwdriver

  Jack Stands

  Ratchet

  Floor Jack

  Trim Tool Set