How to Remove Front Door Panel 2010-16 Cadillac SRX
Created on: 2018-08-24
How to repair, install, fix, change or replace a door panel on 13 Cadillac SRX
-
step 1 :Removing the Front Door Panel
- Pry up the master window switch panel by pressing the clips with a trim tool
- Press the lock tab and disconnect the electrical connectors
- Remove the two Phillips head screws from the door panel
- Pry out the clips from the perimeter of the door with a trim tool
- Lift the door panel up
- Lift up on the latch and slide out the door handle cable
- Slide the handle up and disconnect the window switch connector cable
-
step 2 :Installing the Front Door Panel
- Connect the three wiring harnesses to the door panel
- Connect the door handle cable
- Lift the door panel into place
- Press the clips to the perimeter of the door
- Tighten the Phillips screws to the door
- Connect the window switch connectors
- Press the master window switch into the door panel
Tools needed
-
Phillips Head Screwdriver
Trim Tool Set
Hi. I'm Mike from 1A Auto. We've been selling auto parts for over 30 years.
We're going to pull this trim piece off. We're going to use a trim tool. Go under here. Pry up. It's going to be a little bit tricky over here. We can go back here and pry up back here. Some clips that are holding this down. Grab that and pull up. You can see that these are the different retainers that were holding it down.
To disconnect the electrical connectors, we're going to push on this little lock and pull the connector out just like that, and the same on this one. Push that little lock and pull that connector up.
We're going to remove these two Phillips head screws. We'll use a Phillips head screwdriver. Pull those out. Next, I'm going to use a trim tool, there's some clips that hold the door panel on. We're going to go inside, pry out on the clips. We're going to go all the way around the door panel. Pop those all out. Now, we'll grab the door panel. Lift up and pull it out.
Now, we'll disconnect this cable, you know, lift up, pull out. Pull the cable to the side, pull the ball out. We'll disconnect this electrical connector. There's two little tabs on the side. You'll squeeze those, we're going to move this handle back, and then pull this connector out. May have to wiggle it a little bit, just like that. Pull the door panel off.
We're going to connect this electrical connector first. We're going to line it up, push it in, and then slide this handle over, lock it in place. Then we'll connect this cable right here. We're going to slide the ball through that hole and go to the side and lock that in place.
Now, we're going to push this lock knob through the hole here, just guide it through. Then line your upper part of the door panel. You have to push it in, so it locks in place, the weather strip. Once that's in place, guide the door pins in place and then push them down. Make sure the door panel's flush with the door.
We're going to install these Phillips head screws. Snug that down and the same with this one. Snug that down. Now, we're going to connect this electrical connector here. It goes to the mirror switch and this one goes to the master electrical switch right there. Line this up and lock it down.
Thanks for watching. Visit us at 1A Auto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
How to Check Brake Fluid 2007-14 Toyota FJ Cruiser
Watch this video to learn how to check and inspect the brake fluid in your 07-14 Toyota FJ Cruiser. 1A Auto shows you how to do it yourself!
