How to Remove Traction Control Switch 2002-07 Mazda 6
Created on: 2018-11-05
How to repair, install, fix, change or replace a damaged, worn out, faulty or shorted power traction control switch on 07 Mazda 6.
-
step 1 :Removing the Traction Control Switch
- Pull back the hood release
- Press the tab down behind the release with a flat blade screwdriver
- Slide the hood release and cable toward you and then down and out of the way
- Remove the two 8mm mounting screws
- Pull the kick panel off
- Disconnect the trunk release connector
- Grab the switch firmly
- Press the tab behind the traction control switch up, and push down on the tab on top of the switch
- Pull the switch out
- Press the lock tab and disconnect the wiring harness
-
step 2 :Installing the Traction Control Switch
- Connect the electrical connector to the traction control switch
- Press the switch into the dash so it locks
- Connect the trunk release connector
- Press the kick panel into place
- Tighten the two 8mm mounting screws
- Lift the hood release cable up into place and click it into place by aligning the tabs
Tools needed
-
Phillips Head Screwdriver
8mm Socket
Ratchet
Hi, I'm Mike from 1A Auto. We've been selling auto parts for over 30 years!
Hi, everyone--Sue here at 1A Auto, and today we're going to show you how to remove and replace the traction control switch on an '07 Mazda 6 sedan. If you need any parts for your car, click on the link below and head over to 1aauto.com.
You have to start by removing the hood cable release mount. As you can see here, you take a flathead screwdriver, and there's a tab that you push up on and you pull at the same time. Okay, so I got it. You have to take a flathead screwdriver, and slide it there and pull down on the tab at the same time, so hold the tab completely down. When that tab gets pulled down, get your three sliding ears and you pull it towards you and it pops right down.
Now we're going to remove these two mounting screws. This is an 8mm socket. Grab the kick panel firmly and pull it up. Now with that hanging down we can disconnect the trunk release button. Push on that tab.
We're going to remove our TCS switch, and the tab is right here. I'm just going to grab the switch firmly. Grab the flathead screwdriver, push up on that tab, and then on the same--bring my screwdriver around on the top and push down on that tab, if we can find it. There we go.
With it out now, I can disconnect the lock tab and pull the electrical connecter out. And then we have a directional control switch.
To install it, we're going to reverse procedure. Line the connector up, click it in, slide it right down and you'll see how the two tabs lock.
We're going to reconnect the trunk switch connector. Lock that into place and you've got all your push tabs location. We're going to do the top first. Actually, on this particular model you might line the bottom up and then the top will slide right in, and then just push it on.
And now we those two mounting bolts. We'll mount those. Once those are tightened we'll grab our hood release cable, now I've lift those three tabs. They're going to line up. Click it into place and you're ready to go.
Thanks for watching. Visit us at 1aauto.com for quality auto parts, fast and free shipping and the best customer service in the industry.
How To Replace Seek Volume Radio Control Switch 2000-06 Chevy Tahoe
This video shows you how to install a new volume and seek radio switch on your 2000-06 Chevy Tahoe.
