How to Replace Front Emblem 2008-12 Ford Escape

1. step 1 :Removing the Front Bumper 0:33

   • Remove the 10mm bolts from the top of the grille
   • Pry out the push clips from the front of the wheel well liner with a trim tool
   • Remove the four 10mm bolts from the splash shield
   • Remove the push clip from the inside of the splash shield
   • Remove the 10mm bolts along the front of the splash shield
   • Remove the Phillips screw from the wheel well liner
   • Remove the push clip from the top of the wheel well liner
   • Press the push tab between the bumper and the body (behind the headlight) if the bumper has never been removed
   • Repeat for the other side
   • Disconnect the fog light wiring harnesses
   • Remove the push pin from the radiator slot
   • Pull the bumper forward and off

2. step 2 :Removing the Emblem 4:49

   • Remove the 10mm nuts from the emblem
   • Push the pins through the backside of the grille
   • If needed, widen the slot on one end with a flat blade screwdriver to slide the emblem over and remove it

3. step 3 :Installing the Emblem 6:00

   • Press the emblem onto the grille
   • Tighten the 10mm nuts to the emblem

4. step 4 :Installing the Front Bumper 6:33

   • Insert the bumper into place and press in the sides
   • Insert the push-pins into the radiator slot
   • Press the splash shield into place
   • Tighten the four 10mm bolts to the splash shield
   • Press the push pin into the splash shield
   • Connect the fog light wiring harness
   • Press the push-pins into the wheel well liner
   • Tighten the Phillips screw to the wheel well liner
   • Repeat this procedure for the passenger side
   • Tighten the 10mm bolts to the grille

Tools needed

• Socket Extensions

  Flat Blade Screwdriver

  Phillips Head Screwdriver

  10mm Socket

  Ratchet

  Trim Tool Set