How to Replace Ignition Coil 2001-05 Honda Civic
Created on: 2012-07-17
Ignition coil needs to be replaced? Watch this video and learn how to do this simple repair yourself
-
step 1 :Removing the Ignition Coil
- Turn the two clips on the engine cover with a flat blade screwdriver
- Pull off the engine cover
- Disconnect the ignition coil wiring harness
- Remove the 10mm nut from the ignition coil
- Pull the ignition coil out of the engine
-
step 2 :Installing the New Ignition Coil
- Push the ignition coil into the engine
- Connect the ignition coil wiring harness
- Fasten the 10mm nut onto the ignition coil
- Repeat these steps to replace each ignition coil
- Put the engine cover into place
- Tighten the two clips on the engine cover with a flat blade screwdriver
Tools needed
-
Flat Blade Screwdriver
10mm Wrench
10mm Socket
Ratchet
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we show you how to remove and reinstall the coil. Actually in these vehicles, the 1.4 and 1.6 liter, there's a coil per cylinder. It's recommended to replace these every 100,000 miles. For this, it's pretty easy. All you need is a flat blade screwdriver and a 10 mm wrench or a socket with a ratchet.
Replace the coils. You probably should do it every 100,000 miles. It looks like, actually, this car has been done pretty recently. It's pretty clean. It's pretty straightforward. There are a couple of little locks up here and this piece comes off. There's a harness here. Use your screwdriver and push on the tab up closer to the top and the harness disconnects from each one. Then, you need a 10 mm wrench or socket and ratchet to undo the nut. Pull firmly on the coil, and it comes up out.
Like I said, this looks fairly new. Put it down in. If you want, you can actually connect your harness first. Push the coil down on, put your nut back on and then tighten it up firmly. Like I said, probably every 100,000 miles replace all four. Put this back down and then you go, and they turn 90 degrees to lock in place.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Shop Products
Honda Acura Ignition Coil TRQ ICA61794
Part Details:
- No
- Male
- No
- No
- 3
- Female
- Blade
- 30000 VDC
- Direct Replacement
- Gray
How to Replace Ignition Coils 2007-14 Chevy Suburban 1500
New Ignition Coil from 1AAuto.com How to repair, install, fix, change or replace a bad or broken ignition coil / coil pack on 07, 08, 09, 10, 11, 12, 13, 14 Chevy Suburban.
