How to Replace Speed Sensor 2001-05 Honda Civic
Created on: 2016-05-11
How to remove, install, change or replace a rusted or defective ABS wheel speed sensor on 01, 02, 03, 04, 05 Honda Civic
-
step 1 :Removing the Air Intake
- Remove the seven 10mm nuts from the air intake
- Loosen the hose clamps on the air intake hose
- Disconnect the air intake hoses
- Disconnect the sensor
-
step 2 :Removing the Speed Sensor
- Disconnect the speed sensor connector
- Remove the 12mm bolt from the speed sensor
- Remove the speed sensor
-
step 3 :Installing the New Speed Sensor
- Insert the speed sensor into place
- Tighten the 12mm bolt to the speed sensor
- Connect the speed sensor connector
-
step 4 :Reinstalling the Air Intake
- Insert the air box into place
- Tighten the seven 10mm bolts to the air intake
- Connect the air intake hoses
- Tighten the air intake hose clamps
- Connect the sensor
Tools needed
-
12mm Socket
10mm Socket
Ratchet
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you a speed sensor replacement. This is a 2003 Honda Civic, pretty much the same for this generation Civic. You'll need a new speed sensor from 1AAuto.com and then 10mm and 12mm sockets with a ratchet extension. You shouldn't need anything else, but you may run into problems like we did. If you do run into problems, you'll need pliers, vice grips, flat head screwdriver, and penetrating oil.
If you have a factory air cleaner set up, you'll have to remove that. In this case, the vehicle came with an aftermarket intake. We're going to remove the aftermarket intake with this 10mm bolt, undoing this hose clamp, disconnecting this sensor. Disconnect the connector on the top of the sensor, remove the 12 mm bolt holding it in place.
Unfortunately, we had the bolt that retains the sensor break off, and being unable to twist the sensor to work it out, the sensor broke. These kind of things happen.
What we're going to try to do now is put some penetrating oil on the broken bolt and the remaining piece of the sensor to free it up. Spray penetrating oil on the bottom of the bolt for the vehicle speeding sensor. With the sensor broken off, tapped it down with a hammer to free the sensor up.
I now have vice grips on the shaft of the sensor. We're just going to pull up. With the speed sensor removed, use locking pliers to remove the remainder of the bolt.
Here we have the remains of our old sensor and our new sensor from 1AAuto.com. You can see we have the same three pin connector, same mounting location, the same size and style drive gear. This is going to bolt right up and fix our problem.
Install the new speed sensor into the hole, making sure to line up your bolt. We install the bolt into the sensor and tighten it back down. We install the connector onto the top of the sensor.
Now we're going to reinstall our aftermarket air intake or in your case it could be the OEM air box and intake set up in the reverse order we removed it. After you install the new sensor, you're going to want to drive the vehicle, and make sure your speedometer's working properly.
We just raised and supported our vehicle so the front tires could spin freely.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
How to Replace Output Speed Sensor 2004-09 Dodge Ram
Check out this video on how to replace the output speed sensor on your 04-09 Dodge Ram.
