Replaces
Part Details
Product Features
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet!
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the spark plug wires on this 2002 Ford Escape. It's the same part and similar process on these escapes, from 2001 to 2004. The only item you'll need for this is new spark plug wires from 1AAuto.com.
Pull up the first spark plug wire. Then you want to pull and twist the same time. Then pull off the top of this clip. Pull the spark plug wire free and then disconnect it from the ignition coil.
Take your new spark plug wire and you want the longest one for this spot. Connect it to the ignition coil. Push it back down into that clip and then push the spark plug wire back down over the spark plug.
You'll want to make sure it's pushed all the way down, then you should feel it click onto the spark plug. Then repeat the process on the other spark plug wires just doing one at a time so you don't get them mixed up.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks!
In this video, we're going to show you how to replace an ignition coil on this 2002 Ford Escape. It's the same part and similar process on these Escapes from 2001 to 2004. The items you'll need for this are a new ignition coil from 1AAuto.com, T25 Torx driver or a bit and ratchet, and a flat blade screwdriver.
Pry out on the tabs on either side of the harness by pulling it and the harness will pull free. Then remove these four T25 bolts. This one's right here right into this harness. We'll just fast-forward as Mike removes each of those.
Take your new ignition coil and pull each of the wires off of the old ignition coil and push them into the same spots on the new ignition coil. Now lift your old ignition coil up and out. If any of the wires popped off while you were doing that just make sure they go in the same spots, and then feed your bolts through the holes on the ignition coil.
Then just lower it back down into place, tighten those up, and replace the other two. Then reconnect the harness, and make sure that all your spark plug wires are pushed all the way down into place. You're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
