How to Replace Camshaft Position Sensor 2007-17 Ford Expedition

All right, friends. To find our cam position sensors, I'm gonna let you know there's two of them. There's gonna be one over on the passenger side, and then there's gonna be one located over on the driver side, right above the power steering pump. To replace these, what you'd wanna do is go ahead and press on the tab that's in the center of the wiring harness. And then go ahead and draw this right off of there. I always like to look at the wiring to make sure I don't see any funny colors. Assuming it looks good, set it aside. Now, we're just gonna go ahead and remove the mounting bolt that's located right underneath where the wiring harness was.

Grab onto that sensor, give it a little wiggle, see if you can slide it out. If, for some reason you can't, you can use something and just carefully pry on it. You just wanna be careful not to break it off into the engine. Get that out of there. Let's just go ahead and clean up the area. Just twist as you push this in. Let's install our mounting bolt. Let's go ahead and torque this to 89-inch pounds. Let's go ahead and reconnect it in now. Listen for the click, give it a nice tug. Okay. Now, all you need to do is go ahead and start up your vehicle and make sure you don't have a check engine light.