How to Replace Ignition Coils 1999-2007 Volvo V70 2-4L
Created on: 2018-11-30
How to repair, install, fix, change or replace a bad or broken ignition coil / coil pack on 99, 00, 01, 02, 03, 04, 05, 06, 07 Volvo V70
-
step 1 :Removing the Ignition Coil
- Remove the T30 Torx bolts from the engine cover
- Remove the engine oil cap
- Remove the engine cover
- Replace the engine oil cap
- Press the clips back on the timing belt cover
- Lift the timing belt cover
- Remove the 10mm bolt from the ignition coil
- Disconnect the wiring harness
- Remove the ignition coil
-
step 2 :Installing the Ignition Coil
- Insert the ignition coil into place
- Tighten the 10mm bolt to the ignition coil
- Connect the wiring harness
- Clip on the timing belt cover
- Remove the engine oil cap
- Insert the engine cover into place
- Replace the engine oil cap
- Tighten the T30 Torx bolts to the engine cover
Tools needed
-
Socket Extensions
T30 Driver
10mm Socket
Ratchet
Hi, I'm Mike from 1A Auto. We've been selling auto parts for over 30 years.
Hi, everyone. Sue here at 1A Auto, and today we're going to show you how to install ignition coils on an '03 Volvo V70 with a 2.4 liter. If you need this part or any other part for your car, click on the link below and head on over to 1aauto.com.
Going to start by removing the engine cover. And that's a T30 on all these Torx bolts. And I've taken the liberty of removing all of them already, because that's just going to be tedious. So I'm just going to go around and take the rest of them out. And now this cover will come right up.
Take the oil fuel cap off. I'm going to replace that right away. Now, to take this cover off, there's two clips on the timing cover area. We'll pull back on those clips and push up. Now we have exposed all coils and cylinders in spark plug area.
So we're going to start with, as you can see, this is one, two, three, four, five cylinder, and all of them look identical. So I'll take one coil out and show you how to do one, and it stands for the rest. Each coil is held down with a bolt that has a 10 millimeter socket head on it. So I'm going to break that free. Take that right out. Now you can lift the coil up. Sometimes you might have to wiggle it back and forth. That's it. That's the ignition coil, and this is the tab. We're going to push down on this tab. See how it releases right there? You might have to take a small screwdriver. And we pull it out, and there's your coil.
So here we have the new coil from 1A Auto, and this is the factory coil for our '03 Volvo V70. Exact same design, same connector with the safety lines, same mounting, same seal for the actual rubber seal. These, the new ones, come pre-silicone. So if you need this part or any other part for your car, click on the link below and head on over to 1aauto.com.
We just place it over the cylinder. Find the spark plug head, and push it down on. These came pre-silicone. The ends have silicone on them. And I'm going to line up my connector before I bolt it down. That way I know it's straight on and it clicks. I'm going to take the mounting bolt. Start it by hand. I'm just going to tighten, snug that down. Perfect. Now you just follow the same procedure to do the other four cylinders.
Just line up the two tabs. You'll hear them snap down in. And then take that oil fuel cap off. See how it guides into those teeth? Slide it down. Now we have the eight bolts to put back. Just put them all in by hand. Take my T30 Torx bit, and I'm just going to tighten all the cover bolts down. Tighten down the last one. I'm just bottoming them out and just giving it a nice little tight.
Thanks for watching. Visit us at 1aauto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Volvo C70 S60 S70 S80 V70 XC70 XC90 5 Piece Ignition Coil Set TRQ ICA61532
Part Details:
- 5 Piece
- (5) Ignition Coils
- Direct Replacement
- Black
How to Replace Ignition Coil 2004-06 Chevy Colorado
Check out this video on how to replace an ignition coil on your 04-06 Chevy Colorado.
